Common Tomato Problems, Part 2
While related to onions, garlic needs to be harvested much differently. Garlic is best harvested when it still has five to six green leaves left.
Garlic is sensitive to heat and excess sunlight so leaving garlic in the ground until all the leaves have died down allows potentially hot weather to start "cooking" the bulbs. The more leaves that die the more likely you are to have some of the outer bulb wrappers split which lets dirt, moisture and disease organisms in to the bulb. Garlic has an aggressive root system that makes pulling them difficult if not impossible. Use a shovel or preferably a potato/digging fork to lift the bulbs out of the ground. Carefully knock the loose dirt off the roots. Don t leave in the bulbs in direct sunlight for very long (more than fifteen minutes.) Tie up to ten plants together with twine and hang in a dry and warm location to dry out. Tying more than about ten plants together can result in longer drying periods and more chance for storage molds to start developing. You want the tops to finish drying down so there is no moisture left in the neck when you cut it. Depending on the year and location this may take two to six weeks. Once the necks are dry, trim the tops back to about one inch.
"Hard-necked" cultivars will require pruning clippers to do this, "soft-necked" cultivars can be trimmed with heavy scissors. Brush the remaining dirt out of the roots and trim them back to about a quarter of an inch. If outer bulb wrappers are dirty carefully remove them but don’t remove any more than necessary. Bulb wrappers help protect the cloves.
Carefully check each bulb for soundness by gently squeezing the bulb to check firmness. If any bulbs seem excessively soft, set them apart to be used first. Like onions they are best stored in mesh bags and should never be stored in sealed plastic bags. Paper sacks can be used but pack them lightly. Ideal storage conditions are 32 to 35 degrees and 65 to 70% humidity. For most gardeners you are better to just leave them at cool room temperature. Refrigerator storage conditions very closely replicate fall soil conditions when planting and will stimulate cloves to start bud swelling and germinating. Not all garlic types have the same storage life. Some will only store for 4 to 6 months, while others can store for 10 to 12 months. (Chuck Otte)
Tomato Leaf-Spot Diseases
Two common leaf-spot diseases will likely appear on tomato plants soon if they haven’t already. Septoria leaf spot and early blight are both characterized by brown spots on the leaves.
Septoria leaf spot usually appears earlier in the season than early blight and produces small dark spots. Spots made by early blight are much larger and often have a distorted “target” pattern of concentric circles. Heavily infected leaves eventually turn yellow and drop. Older leaves are more susceptible than younger ones, so these diseases often start at the bottom of the plant and work up. Mulching, caging, or staking keeps plants off the ground, making them less vulnerable. Better air circulation allows foliage to dry quicker than in plants allowed to sprawl.
Mulching also helps prevent water from splashing and carrying disease spores to the plant. In situations where these diseases have been a problem in the past, rotation is a good strategy. It is too late for that now, but keep it in mind for next year. Actually, rotation is a good idea even if you have not had problems in the past. But many gardens are too small to make it practical. If you have room, rotate the location of the tomatoes each year to an area that has not had tomatoes or related crops (peppers, potatoes, eggplant) for several years.
If rotation is not feasible, fungicides are often helpful. Be sure to cover both upper and lower leaf surfaces, and reapply fungicide if rainfall removes it. Plants usually become susceptible when the tomato fruit is about the size of a walnut. Chlorothalonil is a good choice for fruiting plants because it has a 0-day waiting period, meaning that fruit can be harvested once the spray is dry.
Chlorothalonil can be found in numerous products including Fertilome Broad-Spectrum Landscape and Garden Fungicide, Ortho Garden Disease Control, GardenTech Daconil, Bonide Fungonil and others. Be sure to start protecting plants before these diseases are first seen if they have been a problem in the past. It is virtually impossible to control these diseases on heavily infected plants.
If chlorothalonil doesn’t seem to be effective, try mancozeb (Bonide Mancozeb Flowable). Note that there is a five-day waiting period between application and when the fruit can be harvested. A
You may wish to pick some tomatoes before they are fully red just before you spray if you use Mancozeb as the tomato fruit will ripen inside. (Ward Upham)
This is the time of year that gardeners often have trouble with vegetables that are blooming but not setting fruit. There are several possible reasons for this. One condition that can affect several species is overfertilization. Too much nitrogen causes the plant to emphasize vegetative growth, often to the detriment of fruit production. Overfertilization can lead to a delay in flower production and a decrease in fruit set among the flowers produced. This is especially true of tomatoes. Overfertilized tomatoes will produce a large, apparently healthy plant with no flowers or with flowers that don’t set fruit.
Another possible problem with tomatoes setting fruit is temperature. Tomatoes normally won't set if the night temperature is below 50 due to sparse pollen production. They also won't set when nighttime temperatures are above 75 degrees F and daytime temperatures are above 95 degrees F with dry, hot winds. Under such conditions, fertilization is not completed and no fruit develops. However, cherry tomatoes may be more forgiving of high temperatures than the larger slicers and will often set fruit in the heat.
Squash, cucumbers, watermelon, and muskmelon can have a couple of other problems. First, the early flowers on these plants are usually all male. The production of both male and female flowers becomes more balanced as time passes. You can easily tell the difference between the two because only the female flower has a tiny fruit behind the blossom. If you have both, have not over-fertilized, and still have a problem, make sure you have pollinators.
Look for the presence of bees visiting the plants. If you don't see any, try hand-pollinating several flowers. Use a painter’s brush to transfer pollen from the anther of the male flower to the stigma of the female flower. If you get fruit on only those flowers you pollinated, you need more pollinators. Make sure you aren't killing them with overuse of insecticides. If you must use an insecticide, spray near dusk when the flowers have closed. (Ward Upham)
Brown Patch on Tall Fescue
We have been receiving numerous reports of brown patch showing up on tall fescue. This disease is favored by warm night temperatures and extended periods of leaf wetness. If you go outside in the morning and the lawn is covered with dew and the temperature is in the high 60s or higher, it means that conditions are getting right for brown patch. The fungus is primarily a leaf pathogen and does not attack the roots. During severe outbreaks, the fungus may invade the lower leaf sheaths and crown and kill plants. But in most cases, the turfgrass can recover from brown patch. This recovery may take two to three weeks, depending on weather.
There is no way to eliminate brown patch from a lawn. It will persist indefinitely in the soil. Therefore, the disease is not carried from one lawn to another. In almost all cases, the limiting factor for brown patch development is the weather, not the amount of fungal inoculum. Although you can’t eliminate the fungus, cultural practices – especially irrigation – can help control it. Don't water in the evening; instead, water early in the morning. This will help decrease the number of hours the leaf tissue remains wet and susceptible to infection. The frequency of irrigation is not as important as the time of day you do it. Don't overfertilize and certainly don't fertilize when brown patch is active. Also, don't allow your seeding or overseeding rates to become too high.
Fungicides can be effective in preventing brown patch, but the two most commonly used products (Heritage and ProStar) are expensive and not available in small quantities to the general public. Homeowners do have access to some effective products including triadimefon (Green Light Fung-Away), propiconazole (BioAdvanced Fungus Control for Lawns, Fertilome Liquid Systemic Fungicide II) and myclobutanil (Immunox, F-Stop Lawn & Garden). Of the three, triadimefon may be the fungicide of choice because it protects the turf longer (3 to 5 weeks rather than 2 weeks). But my suggestion is not to use fungicides unless you want to maintain a blemish-free yard and are willing to pay for it. In those cases, you would need to be on a preventative spray program, which is very expensive, rather than waiting for symptoms and applying as a curative. These products do not cure an infection already present but are only effective as a preventative. Applications should begin in mid-June and continue through August. Often tall fescue lawns will recover from brown patch but infections this year seem more severe than usual and may require overseeding this fall. (Ward Upham)
Bermudagrass can make a nice lawn if you don't mind its invasiveness and short growing season. But many people dislike both these characteristics. Warm-season grasses, such as bermudagrass, zoysiagrass and buffalograss, green up later than cool-season grasses such as tall fescue and Kentucky bluegrass. They also go dormant earlier in the fall, which can make a lawn unattractive.
Bermuda that invades a cool-season lawn will be brown during much of the spring and fall while the tall fescue portion of the lawn is green. Bermuda is much more drought and heat resistant than cool-season grasses, so it will take over a cool-season lawn during the summer months if it is in full sun.
So, how do you control bermudagrass that has invaded a cool-season lawn? Research conducted in 1996 showed that glyphosate (Round-up, Kleen-up, Killzall, Kleeraway) is the best herbicide for the job. Glyphosate is a nonselective herbicide and will kill everything— including tall fescue or Kentucky bluegrass. Therefore, you will need to reseed treated areas. In our study, we applied a 2% solution of glyphosate on July 15 and again on August 15 on a bermudagrass plot that was more than 15 years old. More than one year later, we saw no regrowth. Glyphosate works best if bermuda is growing well. The better the bermudagrass is growing, the more chemical is taken up and pushed into the roots. Water and fertilize if needed to get it going.
Spray about the middle of July (or when the bermuda is growing well). Use glyphosate (2% solution). Wait two weeks and scalp the lawn (mow as low as possible and remove clippings.) This will prevent dead grass from covering any bermuda that starts to recover. Wait another two weeks and spray again with glyphosate if there is any green. Wait two more weeks and reseed. (Ward Upham)
Although carpenter bees look much like bumblebees, they are easy to identify if you know what to look for. Bumblebees have hairy abdomens that are usually yellow and black. Carpenter bees’ abdomens are shiny blue-black. Carpenter bees are solitary (do not form colonies) and are nonaggressive unless provoked. Only the female possesses a stinger. The male may act aggressive but is harmless. Carpenter bees get their name from the ability of the female to bore into wood. Holes are about a half-inch in diameter and may be 6 inches deep. The female then builds six to eight cells off the main tunnel and lays an egg in each.
Developing larvae feed off of "bee bread" (pollen and nectar) regurgitated by the female bee. Larvae become adults by late August and September, but do not emerge until the following spring. Individual holes may not cause much damage, but cumulative effects of numbers of bees can weaken structures. Painting wood surfaces can make them less attractive to bees. Stains seem to have little effect.
Insecticides, such as Sevin, can be used to treat openings. Sprays and dusts are both effective but sprays may only last for 1 to 2 weeks and require retreatment. Dusts are most easily applied with a puffer duster. It is best to treat near sundown when the bees have returned to their tunnel. (Ward Upham)
Onions are ready to harvest when about half the plants have tops that have fallen over. This is a sign that the onions are mature and need to be pulled out of the ground. Bulbs may sunburn without the foliage to protect them. The secret to onions keeping well is to allow the tops to dry completely before storage. This may take 2 to 3 weeks. Large-necked onions take more time to dry than small-necked onions such as Bermuda types. Move onions to a shaded, well-ventilated area after harvest and spread them out.
After tops are completely dry, remove the dry foliage and compost. Store the bulbs in a cool, dry location. Avoid storage in plastic bags because the lack of air circulation will shorten storage life. Use an open, mesh bag instead. (Ward Upham)
Squash Vine Borer
If you have squash or related plants that suddenly wilt and die, you may have squash vine borer. This insect will bore into the stems of squash, zucchini, pumpkins and gourds. Zucchini squash are a favorite. Cucumbers and melons are usually not a target, although both can be affected by a disease that causes similar symptoms, known as bacterial wilt.
The adult of this insect is a clear-winged moth that resembles a wasp. The forewings are a dark metallic green but the rear wings are clear. The abdomen is orange with black spots. The larva is cream-colored and rather wrinkled. Adults emerge in the spring and lay eggs on or near susceptible plants. Eggs are deposited singly on the underside of the vines and are often concentrated at the base of the plants. Larva bore into the plant and feed for about a month as they move toward the base. Mature larva will exit the plant, burrow into the soil and pupate where they remain until the next year. Each plant can have numerous borers. If you suspect squash vine borer, split the stem of a collapsed plant near where it enters the ground. Infested plants will be hollowed out and mushy and may contain borers.
Unfortunately, there isn't much you can do at this late stage. Control measures should center on prevention.
Suggested preventative controls would include crushing the dull red eggs before they hatch, excavating larvae from stems before they cause much damage or using insecticide applications. Applications should begin when the vines begin to run (too late for that) and reapplied every seven to 10 days through the end of June. Direct the spray at the crown of the plant and the base of runners. Chemicals used for borer control in gardens are permethrin (Eight Vegetable, Fruit & Flower Concentrate; Garden and Farm Insect Control; Lawn & Garden Insect Killer) or bifenthrin (Hi-Yield Bug Blaster II, Bug-B-Gon Insect Killer for Lawns & Gardens) applied as sprays or dusts. If plants wilt, look for the presence of holes and ooze. However, in extreme heat, these plants will temporarily wilt in the afternoon even if undamaged by this insect. (Ward Upham)
Ward Upham runs the Horticulture Response Center in the Department of Horticulture and Natural Resources at Kansas State University. Other contributors include K-State Extension Specialists.